ESP8266

ESP8288 related products
Sort By:  
NodeMCU with 0.9 in spacing
CAD$5.99
NodeMCU - soldered pins
Out of Stock
CAD$6.99
BareBones
Adapter for programming ESP devices with CP2104 or FTDI
CAD$0.00
ESP8266 PCB Antenna
CAD$4.99
ESP-01S - ESP8266 micro module, IOT version, available in Canada
ESP-01S micro board
CAD$3.49
ESP-01 adapter
ESP-01 Bread Board Adapter
Out of Stock
CAD$0.39
ESP-M3 from ArduiniShop.ca
ESP8266 - M3 module
CAD$4.99
ESP-8266 D1 mini board
CAD$5.99
BreakOut module for ESP-01 ESP-01S
CAD$2.49
ATmega256 with Integrated ESP-8266
CAD$18.99
ESP-01 Programmer
CAD$2.99
ESP8266 3D Antenna
CAD$6.99
ESP-01 1 ch. Relay Module
CAD$4.49
Arduino UNO ESP8266 Development Board
CAD$14.99
ESP8266-0.9in (ESP8266-9)
ESP8266 dev board with 0.9 inch spacing..

suitable for breadboard use...

or for use with the ESP8266 Motor Controller shield...

NodeMCU with 0.9 in spacing
CAD$5.99
ESP8266 (ESP8266)
CH340G USB/Serial interface. 1.1" spacing between rows of pins.
NodeMCU - soldered pins
Out of Stock
CAD$6.99
BareBones
ESP Programmer (Criss)
Adapter for programming ESP devices with CP2104 or FTDI.

Devices such as the ESP-01, ESP-07 or any ESP device on a breakout board require 2 signals to upload programs.  While the DTR of a CP2102 or FTDI provides one of these signals you have to provide a jumper or switch to ground GPIO 0 to initiate program up load.  The RTS signal is toggled appropriatly by the esptool uploading script used by the Arduino IDE but the RTS available  on the FTDI or my own CP2104 is not in the correct phase.

This adapter intercepts the DTR and RTS signals and puts them in the correct phase to allow seamless automatic uploading from the Arduino IDE.

A typical setup with an ESP-01 and my CP2104 is shown in the photo.

Note that many FTDI boards have an RTS signal but it is not brought out on the "end" connector, it is typically found on the side of the board.



Adapter for programming ESP devices with CP2104 or FTDI
CAD$0.00
ESP-12F (ESP-12F)
small ESP8266 module with PCB Antenna 4 MByte Flash
ESP8266 PCB Antenna
CAD$4.99
ESP-01S - ESP8266 micro module, IOT version, available in Canada
ESP-01S (ESP-01S)
IOT version:

no Power LED

1 Meg flash


ESP-01S micro board
CAD$3.49
ESP-01 adapter
ESP-01 adapter (8Sprdr)
ESP-01 Bread Board Adapter
ESP-01 Bread Board Adapter
Out of Stock
CAD$0.39
ESP-M3 from ArduiniShop.ca
ESP-M3 (ESP-M3)
Small ESP8266 module with PCB Antenna.

ESP8266 - M3 module
CAD$4.99
D1 mini (D1mini)
Male soldered pins option are facing down for breadboard use.
ESP-8266 D1 mini board
CAD$5.99
ESP-01 BreakOut (ESP01-BO)
BreakOut module for ESP-01 or ESP-01S Male pins unsoldered includd
BreakOut module for ESP-01 ESP-01S
CAD$2.49
mega2560-WiFi (mega2560WiFi)
ATmega2560 Arduino Board with Integrated ESP-8266.

The primary use case is to add Wifi to an ATmega2560 project using "AT" commands sent through Serial3.

This requires no programming of the ESP-8266 and the ATmega2560 is programmed normally via the USB.  There is a 14 pin male header providing connections to some ESP-8266 GPIO Pins.

The ESP-8266 may be programmed independently by changing the position of the slide switch so that the ESP-8266 is connected to the USB UART rather than Serial3 of the mega2560... A "MODE" button is provided to enable IDE program upload to the ESP-8266.

There are DIP switches for custom configuration of the serial communication - First time users should set Switches 3 and 4 to ON and S2 to the TxD3/RxD3 to use the board as a regular ATmega2560 with communication to the ESP via Seria3.println().

We play with our own "toys" and are more than happy to assist you with your specific configuration.


ATmega256 with Integrated ESP-8266
CAD$18.99
ESP-01 Programmer (ESPprg)
ESP-01 Programmer:

This is our own design...

Designed to operate with an FTDI or CP2102 USB to Serial convertor.
Female Headers are provided.

On-Board Switch selects programming mode..

This board also serves as a breakout to allow use of the ESP-01 on a breadboard..
... and may also be used to adapt a CP2102 or FTDI to a proMINI32.
ESP-01 Programmer
CAD$2.99
ESP-07 (ESP-07)
small ESP8266 module with 3D Antenna 4 MByte Flash
ESP8266 3D Antenna
CAD$6.99
ESP-01 Relay Module (ESP01Relay)
10A, 250VAC load
ESP-01 1 ch. Relay Module
CAD$4.49
Arduino UNO ESP8266 (UNO8266)
Arduino ESP8266 UNO format Development board
with microUSB connector for uploading...


Arduino UNO ESP8266 Development Board
CAD$14.99
Per Page      1 - 14 of 14
  • 1